Utah County new-build RRNC referrals

New Construction Radon Systems in Orem, UT

Coordinate radon-resistant rough-ins before foundation pours—or activate an existing passive vent—with an independent Utah County pro.

Why include radon-resistant features before pouring concrete in Utah County?

While central Orem and Provo are largely built out, new subdivisions continue expanding rapidly around the valley's edges—Vineyard grew 28.2% between 2020 and 2024 (to 16,077 residents), Mapleton expanded 30.4% (to 14,812), Santaquin surged 34.0% (to 18,394), and custom infill and ADU projects continue across Orem, Provo, Salem, and Payson. Across southern and eastern foothill growth areas, pre-mitigation radon averages run 5.0 to 7.1 pCi/L.

Planning radon-resistant new construction (RRNC) during excavation and framing keeps piping completely concealed inside interior wall chases and costs a fraction of retrofitting later. The Utah Geological Survey estimates radon-resistant features during new construction cost around $500, versus $1,200 to $1,700 (and up to $2,000 per Utah DEQ) for an active retrofit after move-in.

What Utah Code Section 15A-3-206 says about builder radon pipes

New-home buyers across Utah County should verify radon rough-ins in writing because IRC Appendix F (Radon Control Methods) is not mandated statewide under Utah Code Section 15A-3-206. The statute sets two clear provisions whenever passive radon controls are installed voluntarily:

  • Compliance with IRC Appendix F: Voluntary passive radon installations (or portions of them) must meet IRC Appendix F specifications.
  • No extra municipal inspection: An additional building inspection is not required solely because voluntary passive radon controls were installed.

The five EPA radon-resistant new construction essentials

  • Clean sub-slab gravel bed: At least 4 inches of clean coarse aggregate beneath the slab so soil gas flows smoothly to the suction tee.
  • Continuous plastic sheeting: Minimum 6-mil polyethylene vapor barrier over the gravel before concrete placement.
  • Foundation sealing: Polyurethane caulking on slab control joints, utility pipe sleeves, and sealed sump lids.
  • Interior vertical PVC riser: A 3-inch or 4-inch PVC pipe running straight up through conditioned framing (where household warmth helps create a passive draft) out through the roof, labeled as a Radon System.
  • Pre-wired attic junction box: Power ready next to the attic vent pipe so an inline fan can be installed cleanly if post-occupancy testing shows elevated levels.

EPA emphasizes that passive RRNC reduces radon by roughly 30% to 70%, so every new build must still be tested after move-in to confirm whether passive venting suffices or an attic fan is needed.

Get a Free Estimate

Areas We Cover in Utah County

New-build radon planning and post-closing upgrades

Independent local radon professionals coordinate both pre-pour builder rough-ins and post-occupancy fan activations.

Pre-pour rough-in coordination

Verifies clean gravel depth, suction tee location, vapor sheeting, and hidden interior wall chases before slab concrete arrives.

Post-closing passive stack activation

Inspects an existing builder passive pipe and adds a properly sized attic fan, electrical hookup, and manometer if testing reaches 4.0 pCi/L.

Walkout & ADU foundation crossovers

Links stepped basement slabs and basement-apartment wings with sub-slab crossover piping before interior footings block airflow.

Move-in verification testing

Independent certified 48-hour testing after HVAC startup to document actual indoor radon levels before finishing lower-level rooms.

Published Utah new-build vs. retrofit radon benchmarks

Build stagePublished Utah figurePublic source
Radon-resistant features during new constructionAround $500Utah Geological Survey
Active mitigation retrofit in an existing home$1,200 to $1,700Utah Geological Survey
Standard active residential mitigationAround $1,500 to $2,000Utah DEQ guidance
Passive vs. active expected radon reduction30%–70% passive; 50%–99% activeU.S. EPA Consumer's Guide

Actual custom-home rough-in quotes depend on footprint size, stepped footings, and builder scheduling.

Why Use a Referral for New Construction Radon Systems?

Keep pipes off new stucco and brick

Roughing a vertical chase inside framing avoids strapping visible PVC risers down exterior walls after move-in.

Clear facts on Utah Code § 15A-3-206

Understand why IRC Appendix F is optional statewide and what to confirm in writing with your builder.

Ready for passive-pipe fan upgrades

Already closed on a newer Vineyard, Mapleton, or Salem house with a passive stub? Connect with a pro to inspect and activate it.

Zero homeowner referral fee

Share your build timeline or closing date online to receive a direct quote from an independent Utah County pro.

Contact Us Today for a Free Estimate

Planning a new build, basement ADU, or passive-pipe activation in Utah County? Submit your project stage online.

Get a Free Estimate

Free — no obligations

Steps for radon-resistant new construction

1. Share your construction phase

Tell us your city and whether you are pre-excavation, framing, or moving into a completed home with a passive stack.

2. Review plans with an independent local pro

A Utah County radon specialist evaluates floor plans, stepped footings, and attic wiring access and quotes directly.

3. Complete Appendix F rough-in installation

Sub-slab gravel, sealed sheeting, interior PVC stack, and attic power junction box go in cleanly alongside plumbing and electrical.

4. Test after occupancy & add fan if needed

Run a closed-house test once settled in; if radon stays at or above 4.0 pCi/L (or your target), activate the stack with an attic fan.

Radon Mitigation Services Available in Orem, UT

Get a Free Estimate