Concrete slab & basement suction

Sub-Slab Depressurization in Orem, UT

Request a free estimate from an independent Utah County radon specialist to plan slab coring, pipe routing, and fan sizing.

How does sub-slab depressurization solve radon in Orem and Provo basements?

When furnaces, water heaters, and bathroom exhaust fans run inside an Orem or Provo home—particularly through chilly Utah Valley winters—indoor air pressure drops slightly below the air pressure inside surrounding earth. That pressure gap draws radioactive radon gas straight through concrete floor joints, perimeter cove seams, cracks, and floor drains. Active sub-slab depressurization (SSD) beats the house at its own game by holding a stronger, continuous negative vacuum right underneath the concrete floor.

EPA's Consumer's Guide to Radon Reduction reports that active sub-slab suction is the most dependable residential radon fix, reducing indoor concentrations by 50% to 99%.

How local Utah County soil layers change SSD engineering

Utah Valley's dramatic elevation drop from the Wasatch Range to Utah Lake creates very different sub-slab conditions just miles apart:

  • Coarse east-bench alluvial fans (East Orem, Provo Foothills, Lindon, Mapleton, Elk Ridge): Permeable sand and gravel beds mapped in UGS PI-21 and SS-85 let radon move freely toward foundations—yet that same porosity often allows a single well-positioned suction pit to draw strong vacuum across the entire basement slab.
  • Tighter valley-floor silts and clays (West Orem, Vineyard, Spanish Fork flats): Finer Lake Bonneville sediments resist sub-slab air movement. Independent contractors often test pressure-field extension across the basement to select a higher-suction inline fan, enlarge the excavated aggregate pocket, or tie in a second suction leg.
  • Older 1960s–1980s poured slabs without clean gravel beds: Many mid-century Orem and Provo basements were poured directly over compacted native dirt rather than 4 inches of washed gravel, making careful pit excavation and fan-curve selection essential for reliable results.

Essential safety and installation details

  • Fan outside the living envelope: EPA rules prohibit placing the radon fan inside or underneath habitable rooms—installers mount it in an unconditioned attic, attached garage attic, or exterior wall chase so every indoor pipe section operates under negative suction.
  • Above-roof exhaust termination: Sealed 3-inch or 4-inch PVC vents above the roof edge and well away from windows, decks, and dormers.
  • Manometer and slab sealing: A mounted liquid U-tube manometer shows live vacuum draw, while polyurethane sealant closes floor cracks and sump covers.

Get a Free Estimate

Areas We Cover in Utah County

Inside an active sub-slab depressurization system

Each element works continuously to redirect soil gas safely outside without affecting basement comfort.

Cored slab suction pit

A neat hole cored in a utility closet, under stairs, or furnace room with native soil or gravel excavated beneath to create an open vacuum plenum.

Sloped schedule-40 PVC vent riser

Airtight glued piping routed through a garage, mechanical chase, or color-matched exterior run, pitched to return winter condensate under the slab.

Soil-matched inline radon fan

Continuous-duty exterior or attic fan chosen specifically for high-vacuum clay sub-soils or high-airflow bench gravels.

Vacuum gauge and sump sealing

Clear U-tube manometer labeled with normal operating range plus airtight covers over open sump pits and major slab seams.

Published EPA performance & Utah SSD cost benchmarks

BenchmarkPublished figureSource
Active sub-slab suction radon reduction50% to 99% (up to 99%)U.S. EPA Consumer's Guide
Passive sub-slab suction reduction30% to 70%U.S. EPA Consumer's Guide
Active SSD system in an existing Utah home$1,200 to $1,700Utah Geological Survey
Typical residential active systemAround $1,500 to $2,000Utah DEQ guidance

Older slabs poured directly on native soil, finished basement apartments, and multi-point layouts can raise installation complexity above entry benchmarks.

Why Use a Referral for Sub-Slab Depressurization?

Suited to native-soil mid-century slabs

Independent Utah County pros know how to excavate generous suction pits and size high-suction fans under older 1960s–1980s concrete floors.

Minimal disruption to basement rentals

Discuss quiet mechanical-closet coring and exterior or attic fan placement so basement bedrooms stay peaceful.

Written performance clarity

Ask your independent contractor to outline suction points, routing, and target post-mitigation readings in your written estimate.

Free referral for Utah County owners

Share your foundation details once online and receive a direct contractor quote with zero referral charge.

Contact Us Today for a Free Estimate

Need active sub-slab depressurization in Orem, Provo, or Utah County? Submit your home details online for a free quote.

Get a Free Estimate

Free — no obligations

How an Orem sub-slab system is installed

1. On-site basement & routing review

The contractor inspects furnace rooms, basement apartments, sump pits, and attic or exterior vent paths.

2. Concrete coring & pit excavation

A clean suction hole is cored and soil or gravel is removed beneath the slab to promote broad negative pressure.

3. Sealing, piping & electrical fan hookup

Major slab seams are caulked, sealed PVC piping is routed above the roofline, and an exterior or attic fan is wired to code.

4. Manometer check & follow-up testing

Baseline vacuum is marked on the U-tube gauge, and a verification radon test runs between 24 hours and 30 days after startup.

Radon Mitigation Services Available in Orem, UT

Get a Free Estimate